Good morning. Please explain this to me. ..
create a10mm dead zone in both rails at point X then ‘cross-wire‘ underneath using two jumper wires. Easy... Can I put this mod on the same piece of track as the "jumper cables"? Thanks.
Do I put the jumpers before or after this mod? What gauge wire should I use to make my own jumpers? The Scalextric jumpers are pretty thin and I know we should get as much power to the far track as we can. Also I can't get the 3 meter jumpers in the US or even in the UK.
I read different things here, and other forums, that are part of what people have written about, but we only get a few sentences which leaves us to wonder what the full conversation was. Too many times we are left in the dark in understanding the full modification like when someone said we should set up a multimeter and read the OHMs - but didn't tell what value we should get. What is acceptable as a drop off?
Thanks for your spirit, diligence, hard work